Kleine temperatuur controller W1209 met sensor

Kleine temperatuur controller W1209 met sensor
Euro 16.45 *Prijzen zijn inclusief btw
ArtikelcodeARD182AB
Kleine temperatuur controller W1209 met sensor. Compleet met schakelrelais en instelbaar schakelmoment.  

Aansluitsnoer sensor circa 50cm. Controller wordt gevoed met 12v DC. Relais schakelt maximaal 125 V AC 2 Ampere
Op voorraad / on stock
Kleine temperatuur controller W1209 met sensor. Compleet met schakelrelais en instelbaar schakelmoment.  

Aansluitsnoer sensor circa 50cm. Controller wordt gevoed met 12v DC. Relais schakelt maximaal 125 V AC 2 Ampere

- Temperature range :-50-110 °C
- Dimensions: 48.5 * 40mm
- Temperature control mode: ON / OFF
- Resolution:When temperature is 0.1°C, the resolution is -9.9~99.9, other temperature segment is 1°C
- Control accuracy: 0.1 °C
- Hysteresis accuracy: 0.1°C
- Refresh rate: 0.5S
- High temperature protection: 0-110°C
- Supply voltage: DC 5V
- Static current: ≤ 35MA, attract current ≤ 65MA
- Output voltage: DC 5V
- Output power: 20A relay
- Measurement input: NTC (10K 0.5%) Waterproof Sensor
- Environmental requirements: -10 ~ 60 °C ,Humidity 20% -85%

How to use:
- Connect the power supply and the load, you can supply to the controller,
- Is displayed as a measured temperature,
- Press the SET button, the display flashes the temperature,
- Press - to set the desired temperature,
- After setting press SET to confirm return,
- The controller automatically performs the relay by setting off!
- Lights, LED status descriptions:
- Indicator: Off The relay is switched off, Always indicate the relay is closed.
- LED: Shows LL is the sensor open, showing ?HH is out of range, the thermostat will be forced to close the relay, the display --- as high temperature protection.

Setting method:
Long press SET(5 seconds) to enter the main menu setting
Code
Code description
Setting range
Factory setting
P0 - Cooling/Heating - C/H-C
P1 - Hysteresis setting - 0.5-15
P2 - Highest temperature-110°C
P3 - Lowest temperature--50°C
P4 - Temperature correction--7-7°C
P5 - Delay start time-0-10 minutes
P6 - High temperature alarm-0-110 °C
Long press +- to restore the factory setting(In Shutdown Mode)